Search results for "Fiber Bragg grating"
showing 10 items of 157 documents
Steam sterilization processes affect the stability of clinical thermometers: Thermistor and prototypal FBG probe comparison
2020
Abstract Temperature is one of the most frequently measured physical quantities in clinical environment and a good biomarker of illness. The need for reusable probes, which have to be sterilized to prevent infections, requires the metrological qualification of thermometer probes in response to ageing effects induced by several sterilization processes. In this study, we investigated the effect of repeated sterilizations on both a commonly-used autoclavable thermistor probe and a prototypal Fiber Bragg Gratings (FBG) probe for temperature measurements. Findings highlighted a greater reliability of the proposed FBG probe than the commercial thermistor. Specifically, the FBG probe was able to w…
Sensitivity optimization with cladding-etched long period fiber gratings at the dispersion turning point
2016
This work presents a refractive index sensor based on a long period fiber grating (LPFG) made in a reduced cladding fiber whose low order cladding modes have the turning point at large wavelengths. The combination of these parameters results in an improved sensitivity of 8734 nm/refractive index unit (RIU) for the LP0,3 mode in the 1400-1650 wavelength range. This value is similar to that obtained with thin-film coated LPFGs, which permits to avoid the coating deposition step. The numerical simulations are in agreement with the experimental results. This work was supported in part by the Spanish Ministry of Education and Science-FEDER TEC2013-43679-R. J.L. Cruz also acknowledges financial s…
Fundamental-mode cutoff in liquid-filled Y-shaped microstructured fibers with Ge-doped core
2008
We report on the cutoff characteristics of a Ge-doped Y-shaped microstructured fiber in which the holes are filled with a liquid of refractive index higher than silica but lower than the Ge-doped core. It is found that the cutoff wavelength was very sensitive to temperature variations as a result of the refractive index changes of the liquid. The basic properties of such a fiber permit the fabrication of wideband tunable short-pass filters, as well as temperature sensors with high sensitivity. A temperature sensitivity of 25 nm/degrees C is reported.
Two-core transversally chirped microstructured optical fiber refractive index sensor
2014
We present a sensing architecture consisting of a two-core chirped microstructured optical fiber (MOF) for refractive index sensing of fluids. We show that by introducing a chirp in the hole size, the MOF can be a structure with decoupled cores, forming a Mach-Zehnder interferometer in which the analyte directly modulates the device transmittance by its differential influence on the effective refractive index of each core mode. We show that by filling all fiber holes with analyte, the sensing structure achieves high sensitivity (transmittance changes of 300 per RIU at 1.42) and has the potential for use over a wide range of analyte refractive index.
Measurement of UV-induced losses and thermal effects in photosensitive fibers using whispering gallery modes
2017
When a photosensitive (PS) fiber is exposed to UV-irradiation, a permanent refractive index change is induced in the core. As a result, according to Kramers-Kronig relations, the absorption coefficient (α) is also increased. This increment of the absorption can lead to a significant heating of the fiber when it is illuminated by a moderate optical power. Thermal effects may produce spectral changes in some fiber devices, as for example Long Period Gratings (LPGs) or Fiber Bragg Gratings (FBGs) [1].
ASE narrow‐band noise pulsing in erbium‐doped fiber amplifier and its effect on self‐phase modulation
2019
In this paper, we report a study of the features of polarized and unpolarized narrow-band amplified spontaneous emission (ASE) in a low-doped erbium fiber at 976-nm pumping. We demonstrate that ASE noise can be treated as a train of Gaussian-like pulses with random magnitudes, widths, and inter-pulse intervals. ASE noise can also provide a statistical analysis of these three parameters. We also present the data that reveal ASE noise’s role in optical spectrum broadening through self-phase modulation of light propagating in a communication fiber. In particular, the data show that the ASE noise derivative defines the broadening’s spectral shape.
Highly Sensitive Detection of Naphthalene in Solvent Vapor Using a Functionalized PBG Refractive Index Sensor
2012
We report an optical refractive index sensor system based on a planar Bragg grating which is functionalized by substituted γ-cyclodextrin to determine low concentrations of naphthalene in solvent vapor. The sensor system exhibits a quasi-instantaneous shift of the Bragg wavelength and is therefore capable for online detection. The overall shift of the Bragg wavelength reveals a linear relationship to the analyte concentration with a gradient of 12.5 ± 1.5 pm/ppm. Due to the spectral resolution and repeatability of the interrogation system, this corresponds to acquisition steps of 80 ppb. Taking into account the experimentally detected signal noise a minimum detection limit of 0.48 ± 0.05 pp…
Analysis of a microwave time delay line based on a perturbed uniform fiber Bragg grating operating at constant wavelength
2000
This paper presents the modeling of a new microwave time delay line based on a uniform fiber Bragg grating (FBG) with a section which period has been perturbed. The time delay can be modified by changing the position of the perturbation along the grating. Theoretical results are presented for a 5-cm long uniform grating and optical signal is modulated up to 18 GHz. Experimental setup used magnetic fields to change the period locally along the grating and a 330 ps maximum time delay is shown. Comparison between calculations and measurements show a perfect agreement. Such a delay line offers many advantages for beamforming applications in phased array antennas where the operation at a fixed w…
Fibre Bragg gratings tuned and chirped using magnetic fields
1997
The authors report on the use of magnetic fields in conjunction with magnetostrictive materials for tuning and chirping optical fibre Bragg gratings. The Bragg wavelength shifts as a consequence of the strain induced in the fibre by a magnetostrictive rod when a magnetic field is applied. A tuning range of 1.1 nm has been achieved by a magnetic field of 103 mT and the grating has been chirped by applying non-uniform magnetic fields.
A Fiber Optic Strain Gage Sensor for Measuring Preload in Thick Composite Bolted Joints
2019
Mechanical fastening is a popular choice in joining composites because of the ability to transfer high loads and the ease of assembly and disassembly. In this study, the failure behavior of composite–aluminum single lap bolted joint is investigated. In particular, the effects of varying the preload on the bolt are examined. In order to accurately measure the preload, a specialized sensor that uses a fiber Bragg grating sensor embedded in the bolt is proposed and created. This sensor is realized for the current tests but can be expanded to other applications. An experimental study of bolted single-lap joints varying the tightening torque value has been carried out and, in order to validate t…